Probe Points report
The Probe Points report us used for the output of temperatures at chosen probe points at currently applied boundary conditions .
The report outputs temperatures at points (coordinates x,y,z) defined in the window "Probe Points".
For each point given the application outputs coordinates (values of x,y,z) and the value of calculated temperature. If required a tri-linear interpolation is used to calculate temperature exactly at any point of the model from node values available at the super fine grid.
If the chosen point is located at some space surface the respective dew point (maximum non-condensing air humidity) is calculated and output in %.
If the chosen point is located outside of the boundaries of the construction only its coordinates are output.
Remark: The report includes points of lowest and highest surface temperature for each space surface automatically – space name, space temperature, dew point and f*Rsi value (if applicable) are output – same as in Results report.
Remark: The output of temperature factors f*Rsi will be suppressed if the application setting "fRsi - Two-Space only evaluation" is turned on and there are more than exactly two temperature boundary conditions involved in the model.
Remark: If there are power sources contained within the model this report also includes points of lowest and highest temperature within each power source (to assess overheating for example).
If there is solution of vapour diffusion available also, values of saturation and partial pressure are also output at each point:
If the current value of partial pressure is higher then saturation pressure, a star (*) is shown adjacent to the partial pressure value - this shall alert on possible condensation risk at this respective point.
| VAPOUR-option: Analysis of multidimensional vapour diffusion is only possible with an active VAPOUR-Option of the program.. |
 |
Remark: Point evaluated are defined in the window Probe Points. The list of probe points can be extended directly from Results 3D window (Probe) also.
Remark: Shall partial solution be only available to the report (e.g. some base solution yet not calculated finally, spaces without thermal connection with the model, etc.) the respective result fields will be left empty. Please consider checking the input data or rerunning the solver and checking the output shown within the solver window in such situation.
A report can be:
- viewed on the screen
- saved as PDF, XLS, DOC or RTF file
- printed onto a printer
- searched by keywords
See Toolbar of a Report window
Remark: Similar evaluation of one single probe point is available within graphical evaluation of results .
See also: Coupling Coefficients report, Results report, Toolbar of a Report window, Evaluation windows, Evaluation and Results, Results 3D window, Probe (control panel), Please Wait window